DTC B2785 Communication Malfunction between ECUs Connected by LIN |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2785 | LIN communication from certification ECU stops for certain amount of time
|
|

| 1.CHECK DTC (CERTIFICATION ECU) |
Clear the DTC.
Recheck for DTC.
| Result | Proceed to |
| B2785 output reoccurs | A |
| B2785 output does not reoccur | B |
|
| ||||
| A | |
| 2.CHECK WIRE HARNESS (LIN COMMUNICATION LINE) |

Disconnect the E63 certification ECU connector.
Disconnect the E6 steering lock actuator connector.
Disconnect the E51 ID code box connector.
Disconnect the ID instrument panel junction block connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| E63-10 (LIN) - ID-9 (LIN1) | Below 1 Ω |
| E63-10 (LIN) or ID-9 (LIN1) - Body ground | 10 kΩ or higher |
| E63-10 (LIN) - E6-5 (LIN) | Below 1 Ω |
| E63-10 (LIN) or E6-5 (LIN) - Body ground | 10 kΩ or higher |
| E63-10 (LIN) - E51-3 (LIN1) | Below 1 Ω |
| E63-10 (LIN) or E51-3 (LIN1) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK OPERATION OF CERTIFICATION ECU |
Replace the certification ECU with a normally functioning or new one.
Check for DTC.
| Result | Proceed to |
| B2785 output reoccurs | A |
| B2785 output does not reoccur | B |
|
| ||||
| A | |
| 4.CHECK OPERATION OF MAIN BODY ECU |
Replace the instrument panel junction block assembly (main body ECU) with a normally functioning or new one.
Check for DTC.
| Result | Proceed to |
| B2785 output reoccurs | A |
| B2785 output does not reoccur | B |
|
| ||||
| A | |
| 5.CHECK OPERATION OF STEERING LOCK ECU |
Replace the steering lock actuator assembly with a normally functioning or new one.
Check for DTC.
| Result | Proceed to |
| B2785 output reoccurs | A |
| B2785 output does not reoccur | B |
|
| ||||
| A | ||
| ||