TRANSFER CASE OIL SEAL (for RH Side) > REPLACEMENT |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. DRAIN MANUAL TRANSAXLE OIL (for Manual Transaxle) |
Remove the filler plug and gasket.
Remove the drain plug and gasket, and drain the oil.
Install a new gasket and the drain plug.
| 3. DRAIN TRANSFER OIL |
Remove the drain plug and gasket, and drain the oil.
Install a new gasket and the drain plug.
| 4. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH |
![]() |
Squeeze the ends of the snap ring, and remove the snap ring from the bearing bracket.
Remove the bearing bracket bolt and front drive shaft from the bearing bracket.
| 5. REMOVE DRIVE SHAFT BEARING BRACKET |
Remove the 3 bolts and bracket from the transaxle.
| 6. REMOVE TRANSFER CASE OIL SEAL (for RH Side) |
![]() |
Using SST, tap out the oil seal from the transfer.
| 7. INSTALL TRANSFER CASE OIL SEAL (for RH Side) |
![]() |
Using SST and a hammer, tap in the oil seal.
Coat a new oil seal lip with MP grease.
| 8. INSTALL DRIVE SHAFT BEARING BRACKET |
Install the bracket to the transaxle with the 3 bolt.
| 9. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH |
Coat the splines of the inboard joint shaft with gear oil.
Align the shaft splines and securely insert the drive shaft.
![]() |
Squeeze the ends of the snap ring and install it to the bearing bracket.
Install a new bearing bracket bolt.
| 10. ADD TRANSFER OIL |
| 11. INSPECT TRANSFER OIL |
![]() |
Remove the transfer case plug No. 2 (for filler) and gasket.
Check that the oil level is between 0 to 5.0 mm (0 to 0.20 in.) from the bottom lip of the case plug (for filler) hole.
If the result is not as specified, add transfer oil.
When the oil level is too low, check for oil leakage.
Install a new gasket into the case plug (for filler) and then install the plug.
| 12. ADD MANUAL TRANSAXLE OIL (for Manual Transaxle) |
| 13. INSPECT MANUAL TRANSAXLE OIL (for Manual Transaxle) |
Stop the vehicle in a level place.
Remove the transaxle filler plug and gasket.
![]() |
Check that the oil level is between 0 to 5 mm (0 to 0.20 in.) from the bottom lip of the filler plug opening. If the result is not as specified, add transaxle oil.
Check for oil leakage if the oil level is low.
Install the transaxle filler plug and a new gasket.
| 14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |