ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System) > Security Indicator Light Circuit |

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SECURITY INDICATOR LIGHT) |
Select the Active Test, use the intelligent tester (with CAN VIM) to generate a command, and then check that the security indicator light operation is normal.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Security Indic | Turn security indicator light | ON or OFF | - |
|
| ||||
| NG | |
| 2.CHECK WIRE HARNESS (TRANSPONDER KEY ECU AND BODY GROUND - SECURITY INDICATOR LIGHT) |

Disconnect the E50 ECU connector.
Disconnect the E25*1 or E26*2 light connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| E50-8 (IND) - E25-8 (SEC) | Below 1 Ω |
| E25-5 (E) - Body ground | |
| E50-8 (IND) or E25-8 (SEC) - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
| E50-8 (IND) - E26-10 (LP) | Below 1 Ω |
| E26-7 (GND) - Body ground | |
| E50-8 (IND) or E26-10 (LP) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT TRANSPONDER KEY ECU (OUTPUT) |
![]() |
Remove the transponder key ECU with its connectors still connected.
Measure the voltage of the ECU.
| Tester Condition | Condition | Specified Condition |
| E50-8 (IND) - Body ground | Engine immobiliser system is set | 11 to 14 V and below 1 V output alternately |
|
| ||||
| OK | ||
| ||