Home › TRANSMISSION ยท U241E AUTOMATIC TRANSAXLE › OIL PUMP

OIL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT OIL PUMP OIL SEAL


    D003654E01
  1. Using SST, install a new oil seal to the pump.

    SST
    09350-32014   (09351-32140)

    HINT:
    The seal end should be flush with the outer edge of the oil pump.

  1. Coat the lip of the oil seal with petroleum jelly.



2. INSTALL FRONT OIL PUMP BODY O-RING


    C055817E03
  1. Coat a new O-ring with ATF, and install it to the oil pump body.



3. INSTALL FRONT OIL PUMP DRIVEN GEAR


    D009206E08
  1. Coat the front oil pump driven gear with ATF, and install it to the oil pump body with the maked side facing up.



4. INSTALL FRONT OIL PUMP DRIVE GEAR


    D009206E09
  1. Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the maked side facing up.



5. INSTALL STATOR SHAFT ASSEMBLY


    D003651E02
  1. Set stator shaft by aligning each bolt hole.

  1. Using a T30 ''torx'' socket, install the 11 bolts.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }



6. INSTALL CLUTCH DRUM OIL SEAL RING


D003655E01

NOTICE:
Do not expand the ring ends excessively.

  1. Install the 2 clutch drum oil seal rings.



7. INSPECT OIL PUMP ASSEMBLY


    D009205E01
  1. Turn the drive gear with 2 screwdrivers and make sure it rotates smoothly.

    NOTICE:
    Be careful not to damage the oil seal lip.