FORWARD CLUTCH > REASSEMBLY |
| 1. INSTALL INPUT SHAFT OIL SEAL RING |
![]() |
Compress the oil seal ring from both sides to reduce dimension A.
Coat the oil seal ring with ATF and install it to the input shaft.
| 2. INSTALL FORWARD CLUTCH PISTON O-RING |
![]() |
Coat 2 new O-rings with ATF, and install them to the forward clutch piston.
| 3. INSTALL FORWARD CLUTCH PISTON SUB-ASSEMBLY |
![]() |
Install the forward clutch piston to the forward clutch drum.
| 4. INSTALL FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() |
Place the forward clutch return spring onto the forward clutch piston.
![]() |
Place SST on the return spring, and compress the return spring with a press.
Install the snap ring with a snap ring expander. Be sure the end gap of the snap ring is not aligned with the spring retainer claw.
| 5. INSTALL FORWARD CLUTCH FLANGE HOLE SNAP RING |
![]() |
Install the 5 plates, 5 discs and flange.
![]() |
Using a screwdriver, install the snap ring.
Check that the end gap of the snap ring is not aligned with one of the cutouts.
| 6. INSPECT PACK CLEARANCE OF FORWARD CLUTCH |
![]() |
Install the forward clutch on the oil pump.
Using a dial indicator, measure the forward clutch piston stroke while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).
| No. | Thickness | No. | Thickness |
| 1 | 3.00 mm (0.1181 in.) | 4 | 3.45 mm (0.1358 in.) |
| 2 | 3.15 mm (0.1240 in.) | 5 | 3.60 mm (0.1417 in.) |
| 3 | 3.30 mm (0.1299 in.) | - | - |
| 7. INSPECT FORWARD MULTIPLE DISC CLUTCH DISC |
![]() |
Inspect the clutch disc rotation.
After inserting the multiple disc clutch into the multiple disc clutch hub, rotate the forward clutch and check that the disc lightly rotates.