DIRECT CLUTCH > INSPECTION |
| 1. INSPECT PACK CLEARANCE OF DIRECT CLUTCH |
![]() |
Install the direct clutch and needle roller bearing on the transaxle rear cover.
Using a dial indicator, measure the direct clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).
| 2. INSPECT DIRECT MULTIPLE DISC CLUTCH DISC |
![]() |
Check to see if the sliding surface of the disc, plate and flange are worn or burnt.
If necessary, replace them.
| 3. INSPECT DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() |
Using a vernier caliper, measure the free length of the spring together with the spring seat.