DIRECT CLUTCH > DISASSEMBLY |
| 1. INSPECT PACK CLEARANCE OF DIRECT CLUTCH |
![]() |
Install the direct clutch and needle roller bearing on the transaxle rear cover.
Using a dial indicator, measure the direct clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).
| 2. REMOVE DIRECT MULTIPLE DISC CLUTCH DISC |
![]() |
Using a screwdriver, pry out the snap ring from the direct clutch drum.
![]() |
Remove the flange, 3 discs and 3 plates from the direct clutch drum.
| 3. INSPECT DIRECT MULTIPLE DISC CLUTCH DISC |
![]() |
Check to see if the sliding surface of the disc, plate and flange are worn or burnt.
If necessary, replace them.
| 4. REMOVE DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() |
Place SST on the clutch balancer and compress the spring with a press.
Using a snap ring expander, remove the snap ring from the direct clutch drum.
![]() |
Remove the clutch balancer from the direct clutch drum.
![]() |
Remove the piston return spring from the direct clutch drum.
![]() |
Install the direct clutch drum on the transaxle rear cover.
Holding the direct clutch piston with your hand, apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) to the transaxle rear cover to remove the direct clutch piston.
| 5. INSPECT DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() |
Using a vernier caliper, measure the free length of the spring together with the spring seat.