DIRECT CLUTCH > REASSEMBLY |
| 1. INSTALL DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() |
Coat the direct clutch piston with ATF, and install it to the direct clutch drum.
![]() |
Install the piston return spring to the direct clutch drum.
![]() |
Install the clutch balancer to the direct clutch drum.
![]() |
Place SST on the clutch balancer and compress the piston return spring with a press.
Using a snap ring expander, install the snap ring to the direct clutch drum.
| 2. INSTALL DIRECT MULTIPLE DISC CLUTCH DISC |
![]() |
Install the 3 plates, 3 discs and flange.
![]() |
Using a screwdriver, install the snap ring.
Check that the end gap of the snap ring is not aligned with one of the cutouts.
| 3. INSPECT PACK CLEARANCE OF DIRECT CLUTCH |
![]() |
Install the direct clutch on the transaxle rear cover.
Using a dial indicator, measure the direct clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).
| No. | Thickness | No. | Thickness |
| 1 | 3.0 mm (0.118 in.) | 4 | 3.3 mm (0.130 in.) |
| 2 | 3.1 mm (0.122 in.) | 5 | 3.4 mm (0.134 in.) |
| 3 | 3.2 mm (0.126 in.) | 6 | 3.5 mm (0.138 in.) |
| 4. INSPECT DIRECT MULTIPLE DISC CLUTCH CLUTCH DISC |
![]() |
Inspect the clutch disc rotation.
Check that the disc rotates when rotating the disc after inserting the rear planetary sun gear.