Home › TRANSMISSION ยท U241E AUTOMATIC TRANSAXLE › SECOND BRAKE PISTON

SECOND BRAKE PISTON > DISASSEMBLY

for Preparation Click here



1. REMOVE 2ND BRAKE PISTON RETURN SPRING SUB-ASSEMBLY


    D003796E04
  1. Place SST on the return spring and compress.

    SST
    09387-00060  

  1. Using a screwdriver, pry out the snap ring.



    C083462E01
  1. Remove the piston return spring.



2. INSPECT 2ND BRAKE PISTON RETURN SPRING SUB-ASSEMBLY


    D003824E02
  1. Using a vernier caliper, measure the free length of the spring together with the spring seat.

    Standard free length:
    16.61 mm (0.6539 in.)



3. REMOVE 2ND BRAKE PISTON


    C083463E01
  1. Hold the 2nd brake piston and apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) to the 2nd brake cylinder to remove the 2nd brake piston.



4. REMOVE 2ND BRAKE PISTON O-RING


    C083465E01
  1. Remove the 2 O-rings from the 2nd brake piston.