UNDERDRIVE CLUTCH > DISASSEMBLY |
| 1. INSPECT UNDERDRIVE PACK CLEARANCE |
Install the underdrive clutch to the transaxle case.
![]() |
Install a dial indicator as shown in the illustration.
![]() |
Measure the underdrive clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).
| 2. REMOVE NO. 1 UNDERDRIVE CLUTCH DISC |
![]() |
Using a screwdriver, pry out the snap ring.
![]() |
Remove the flange, 3 discs and 3 plates from the underdrive clutch drum.
| 3. INSPECT NO. 1 UNDERDRIVE CLUTCH DISC |
![]() |
Check to see if the sliding surface of the disc, plate and flange are worn or burnt. If necessary, replace them.
| 4. REMOVE UNDERDRIVE CLUTCH PISTON SET |
![]() |
Place SST on the clutch balancer and compress the spring with a press.
Using a snap ring expander, remove the snap ring.
![]() |
Remove the clutch balancer and piston return spring from the underdrive clutch drum.
![]() |
Install the underdrive clutch to the transaxle case.
![]() |
Holding the underdrive clutch piston with your hand, apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) to the transaxle case to remove the underdrive clutch piston.
| 5. INSPECT UNDERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() |
Using a vernier caliper, measure the free length of the spring together with the spring seat.
| 6. REMOVE UNDERDRIVE CLUTCH DRUM O-RING |
![]() |
| 7. INSPECT UNDERDRIVE CLUTCH DRUM SUB-ASSEMBLY |
![]() |
Using a caliper gauge, measure the inside diameter of the underdrive clutch drum bush.