Home › TRANSMISSION ยท U241E AUTOMATIC TRANSAXLE › UNDERDRIVE PLANETARY GEAR

UNDERDRIVE PLANETARY GEAR > REASSEMBLY

for Preparation Click here



1. INSTALL UNDERDRIVE PLANETARY RING GEAR


    D008112E02
  1. Install a new snap ring to the outer race of the tapered roller bearing.



    D008113E01
  1. Using a piston ring compressor, squeeze the snap ring.



    D008114E01
  1. Using SST a press, press in the outer race of the tapered roller bearing.

    SST
    09950-60020   (09951-00890)
    09950-70010   (09951-07100)



    D003827E04
  1. Install the underdrive planetary ring gear to the counter driven gear.



    D003826E03
  1. Using snap ring pliers, install the snap ring.



2. INSTALL UNDERDRIVE PLANETARY GEAR ASSEMBLY


    D003692E01
  1. Using a press, install the tapered roller bearing.



    D008117E01
  1. Install the counter driven gear with planetary ring gear to the underdrive planetary gear.



    D008118E01
  1. Using SST and a press, press in the tapered roller bearing.

    SST
    09316-60011   (09316-00011)

    NOTICE:
    Press in the counter driven gear while rotating it.



    D003694E02
  1. Using a press, press in the parking lock gear.

    NOTICE:
    Press in the counter driven gear while rotating it.



    D008120E02
  1. Using SST and a press, press in the differential drive pinion.

    NOTICE:
    Press in the counter driven gear while rotating it.

    SST
    09506-35010  
    09950-60010   (09951-00250)



    D008121E02
  1. Using SST and a press, press in the cylindrical roller bearing inner race.

    NOTICE:
    Press in the counter driven gear while rotating it.

    SST
    09506-35010  
    09950-60010   (09951-00250)



    D025609E05
  1. Clamp the underdrive planetary gear in a soft jaw vise.

    NOTICE:
    Be careful not to damage the differential drive pinion.

  1. Using SST, install a new lock nut.

    Torque:
    280 N*m{ 2,855 kgf*cm , 207 in.*lbf }

    SST
    09564-16020  

    HINT:
    Use a torque wrench with a fulcrum length of 750 mm (29.53 in.)



    D025594E02
  1. Using SST and a torque wrench, measure the turning torque of underdrive planetary gear assembly while rotating the torque wrench at 60 rpm.

    SST
    09564-16020  
    09387-00050  

    Torque:
    Standard turning torque at 60 rpm:
    0.23 to5.01 N*m{ 2 to 51 kgf*cm , 2.0 to 44.3 in.*lbf }

    HINT:
    Use a torque wrench with a fulcrum length of 160 mm (6.30 in.).



    D003852E01
  1. Using a pin punch and hammer, stake the lock nut.

    NOTICE:
    Make sure that there are no cracks on the nut.