DIFFERENTIAL CASE > DISASSEMBLY |
| 1. REMOVE FRONT DIFFERENTIAL RING GEAR |
![]() |
Place the matchmarks on the ring gear and differential case.
![]() |
Remove the 10 bolts.
![]() |
Using a plastic-faced hammer, tap on the ring gear to remove it from the case.
| 2. REMOVE FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING |
![]() |
Using SST, remove the front differential case tapered roller bearing front inner race from the differential case.
![]() |
Using SST, remove the front differential case tapered roller bearing front outer race and differential case washer.
| 3. REMOVE FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING |
![]() |
Using SST, remove the front differential case tapered roller bearing rear inner race from the differential case.
![]() |
Using SST, remove the front differential case tapered roller bearing rear outer race from the differential case washer.
| 4. REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN |
![]() |
Using a punch and hammer, loosen the staked part of the differential case.
![]() |
Using a pin punch (5 mm), tap out the pin from the ring gear side.
| 5. REMOVE NO. 1 FRONT DIFFERENTIAL PINION SHAFT |
![]() |
Remove the front differential pinion shaft from the differential case.
| 6. REMOVE FRONT DIFFERENTIAL SIDE GEAR |
![]() |
Remove the 2 front differential pinions, 2 pinion thrust washers, 2 front differential side gears and 2 side gear thrust washers from the differential case.
| 7. REMOVE DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL |
![]() |
Place the transaxle case in a vise.
Using SST, remove the oil seal.
| 8. REMOVE TRANSAXLE HOUSING OIL SEAL |
![]() |
Place the transaxle housing in a vise.
Using SST, remove the oil seal.