NAVIGATION SYSTEM (for DVD) > The Other Caller cannot Hear Your Voice, or Your Voice is too Quiet or Distorted |
| 1.CHECK CELLULAR PHONE |
Check if the other side can hear your voice properly.
|
| ||||
| OK | |
| 2.CHECK SETTINGS |
![]() |
Check if the mute switch is set to on.
| Result | Proceed to |
| OK (for 3ZR-FAE) | A |
| OK (except 3ZR-FAE) | B |
| NG | C |
|
| ||||
|
| ||||
| A | |
| 3.CHECK MICROPHONE (NAVIGATION CHECK MODE) |
![]() |
Enter the "MICROPHONE & VOICE RECOGNITION CHECK" mode (Click here).
When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.
Push the recording switch and perform voice recording.
Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.
|
| ||||
| OK | ||
| ||
| 4.CHECK SETTINGS |
![]() |
Enter the "Handsfree Voice Quality Set" mode (Click here).
Check if the "Send Voice Level" is set to "0".
Check if the volume is set to the minimum or maximum level.
|
| ||||
| OK | |
| 5.CHECK MICROPHONE (NAVIGATION CHECK MODE) |
![]() |
Enter the "MICROPHONE & VOICE RECOGNITION CHECK" mode (Click here).
When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.
Push the recording switch and perform voice recording.
Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.
|
| ||||
| OK | ||
| ||