WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Entry and Start System) > REGISTRATION |
| 1. DESCRIPTION OF CODE REGISTRATION |
| 2. REGISTER RECOGNITION CODE (USING INTELLIGENT TESTER) |
Turn the ignition switch ON.
Select the menu on the intelligent tester.
Select "RAV4" from the menu.
Select "Main Body".
Select "Wireless Registration".
Press both LOCK and UNLOCK switches between 1 to 1.5 seconds.
Press either switch for more than 1 second within 3 seconds.
Check the response to the registration completion.

Perform either of the following to complete the registration of recognition codes:
| 3. REGISTER RECOGNITION CODE (USING SWITCH OPERATION) |
The following conditions should be met.
Insert and remove the key into / from the ignition key cylinder twice (Insert → Remove →Insert → Remove) within 5 seconds.
Perform the following operations within 40 seconds.
Close and open the driver side door twice (Close → Open → Close → Open).
Insert and remove the key into / from the ignition key cylinder once (Insert → Remove).
Close and open the driver side door twice (Close → Open → Close → Open).
Insert the key into the ignition key cylinder and close all doors.
Perform the following operations within 40 seconds.
Turn the ignition switch from ON to OFF at approximately 1 second intervals, operate the ignition switch according to the number of times shown below.

Remove the key from the ignition key cylinder.
Check the response of the selected mode within 5 seconds.

Within 40 seconds of completing the confirmation mode operation, press the LOCK and UNLOCK switches on the transmitter simultaneously.
After completing the above step, press a single switch (LOCK or UNLOCK) within 5 seconds.
After completing the above step, check the response to the registration completion within 3 seconds.

Perform either of the following to complete the registration of recognition codes: