Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT ASSEMBLY (w/ Hood Moulding)

HEADLIGHT ASSEMBLY (w/ Hood Moulding) > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE NO. 2 HEADLIGHT BULB


    E209219
  1. Turn the bulb in the direction indicated by the arrow and remove it.



2. REMOVE NO. 1 HEADLIGHT BULB


    E208557
  1. Turn the back cover in the direction indicated by the arrow and remove it.



    E207730
  1. Disconnect the connector.

  1. Turn the bulb in the direction indicated by the arrow and remove it.



3. REMOVE FRONT TURN SIGNAL LIGHT SOCKET


    E209220
  1. Turn the socket in the direction indicated by the arrow and remove it.



4. REMOVE FRONT TURN SIGNAL LIGHT BULB
  1. Remove the bulb.



5. REMOVE CLEARANCE LIGHT SOCKET


    E156671
  1. Turn the socket in the direction indicated by the arrow and remove it.



6. REMOVE CLEARANCE LIGHT BULB
  1. Remove the bulb.



7. REMOVE HEADLIGHT COVER SEAL LH


    E207731
  1. Using a dryer, heat the backside of the headlight.

  1. Remove the seal.