Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT ASSEMBLY (w/ Hood Moulding)

HEADLIGHT ASSEMBLY (w/ Hood Moulding) > REASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL HEADLIGHT COVER SEAL LH


    E207736
  1. Align a new headlight seal with the cutout of the lens and install it as shown in the illustration.



2. INSTALL CLEARANCE LIGHT BULB
  1. Install the bulb.



3. INSTALL CLEARANCE LIGHT SOCKET


    E156672
  1. Turn the socket in the direction indicated by the arrow to install it.



4. INSTALL FRONT TURN SIGNAL LIGHT BULB
  1. Install the bulb.



5. INSTALL FRONT TURN SIGNAL LIGHT SOCKET


    E209221
  1. Turn the socket in the direction indicated by the arrow to install it.



6. INSTALL NO. 1 HEADLIGHT BULB


    E207737
  1. Turn the bulb in the direction indicated by the arrow to install it.

  1. Connect the connector.



    E208558
  1. Turn the back cover in the direction indicated by the arrow to install it.



7. INSTALL NO. 2 HEADLIGHT BULB


    E209222
  1. Turn the bulb in the direction indicated by the arrow to install it.