Home › ENGINE ยท 1AZ-FE › EXHAUST › EXHAUST PIPE

EXHAUST PIPE > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)


A124802E01
  1. Disconnect the sensor connector.

  1. Using SST, remove the sensor from the front exhaust pipe.

    SST
    09224-00010  



3. REMOVE TAILPIPE ASSEMBLY
  1. Remove the 2 bolts and 2 compression springs.

  1. Disconnect the 2 exhaust pipe supports, and remove the tailpipe.



  1. Remove the gasket from the center exhaust pipe.


    A126834



4. REMOVE CENTER EXHAUST PIPE ASSEMBLY
  1. Remove the 2 bolts.



  1. Disconnect the 3 exhaust pipe supports, and remove the center exhaust pipe.


    A126832



    A127754
  1. Remove the gasket from the front exhaust pipe.



5. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Remove the 2 bolts, 2 compression springs and front exhaust pipe.



  1. Remove the gasket from the exhaust manifold.


    A126831