EXHAUST PIPE > INSTALLATION |
| 1. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
![]() |
Using a vernier caliper, measure the free length of the compression spring.
Using a wire brush, remove any foreign matter from the gasket installation surface.
![]() |
Install a new gasket by hand so that its surface is flush with the exhaust manifold.
Install the front exhaust pipe and 2 compression springs with the 2 bolts.

| 2. INSTALL CENTER EXHAUST PIPE ASSEMBLY |
Install a new gasket onto the front exhaust pipe.
Connect the 3 exhaust pipe supports to install the center exhaust pipe.
Install the 2 bolts.

| 3. INSTALL TAILPIPE ASSEMBLY |
![]() |
Using a vernier caliper, measure the free length of the compression spring.
![]() |
Install a new gasket by hand so that its surface is flush with the center exhaust pipe.
Connect the 2 exhaust pipe supports to install the tailpipe.
Install the 2 compression springs and 2 bolts.

| 4. CONNECT HEATED OXYGEN SENSOR |
Rotate the sensor counterclockwise the same number of times as recorded in the removal procedure, and then connect it to the front exhaust pipe by hand.
![]() |
Using SST, tighten the sensor.
Connect the grommet to the floor panel.
| 5. INSPECT FOR EXHAUST GAS LEAK |