BRAKE ACTUATOR (w/o VSC) > INSTALLATION |
| 1. INSTALL BRAKE ACTUATOR ASSEMBLY WITH BRACKET |
![]() |
Install the actuator with bracket with the 3 nuts.
![]() |
Connect the brake tube clamp to the bracket.
Connect the actuator connector.
| 2. CONNECT BRAKE LINE |
![]() |
Using a union nut wrench, connect the 6 brake lines to the correct locations on the actuator, as shown in the illustration.
| 3. FILL RESERVOIR WITH BRAKE FLUID |
| 4. BLEED AIR FROM BRAKE MASTER CYLINDER |
![]() |
Using a union nut wrench, disconnect the 2 brake lines from the master cylinder.
Slowly depress and hold the brake pedal.
![]() |
Block the outer holes with your fingers, and release the pedal.
Repeat the 2 previous steps 3 or 4 times.
Using a union nut wrench, connect the 2 brake lines to the master cylinder.
| 5. BLEED AIR FROM BRAKE LINE |

Remove the bleeder plug cap.
Connect the vinyl tube to the bleeder plugs.
Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed.
When fluid stops coming out, immediately tighten the bleeder plug. Then release the pedal.
Repeat the 2 previous steps until all the air in the brake fluid is gone.
Tighten the bleeder plug.
Install the cap.
Bleed air from the brake line for each wheel by repeating the above procedures.
| 6. BLEED AIR FROM CLUTCH LINE (for Manual Transaxle) |
Fill the brake reservoir with brake fluid and bleed the clutch system.
| 7. CHECK BRAKE FLUID LEVEL IN RESERVOIR |
![]() |
Check the fluid level and add fluid if necessary.
| 8. CHECK FOR BRAKE FLUID LEAKAGE |
| 9. INSTALL AIR CLEANER CASE SUB-ASSEMBLY (for 1AZ-FE) |
Install the air cleaner case (Click here).
| 10. INSTALL AIR CLEANER CASE SUB-ASSEMBLY (for 2AZ-FE) |
Install the air cleaner case (Click here).
| 11. INSTALL AIR CLEANER CASE SUB-ASSEMBLY (for 3ZR-FAE) |
Install the air cleaner case (Click here).
| 12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 13. CHECK BRAKE ACTUATOR ASSEMBLY WITH INTELLIGENT TESTER |
Check the brake actuator with the intelligent tester (Click here).