STEERING ANGLE SENSOR > INSTALLATION |
| 1. INSTALL STEERING ANGLE SENSOR |
![]() |
Align the locating pins, attach the 6 claws to install the sensor to the spiral cable.
| 2. INSTALL SPIRAL CABLE SUB-ASSEMBLY (for LHD) |
Check that the front wheels are facing straight ahead.
Set the turn signal switch to the neutral position.
![]() ![]() |
Install the spiral cable.
Connect the connectors to the spiral cable.
![]() |
Attach the 4 clips to the column cover (upper).
![]() |
Install the steering column cover (upper).
| 3. INSTALL SPIRAL CABLE SUB-ASSEMBLY (for RHD) |
Check that the front wheels are facing straight ahead.
Set the turn signal switch to the neutral position.
![]() ![]() |
Install the spiral cable.
Connect the connectors to the spiral cable.
![]() |
Attach the 4 clips to the column cover (upper).
![]() |
Install the steering column cover (upper).
| 4. INSTALL STEERING COLUMN COVER (for LHD) |
![]() |
Attach the claw to install the upper steering column cover.
![]() |
Attach the 4 claws to install the lower steering column cover.
| 5. INSTALL STEERING COLUMN COVER (for RHD) |
![]() |
Attach the claw to install the steering column cover upper.
![]() |
Attach the 4 claws to install the steering column cover lower.
| 6. INSTALL STEERING WHEEL ASSEMBLY (for LHD) |
![]() |
Align the matchmarks and install the steering wheel to the steering column.
Install the nut.
Connect all the connectors to the spiral cable.
| 7. REMOVE STEERING WHEEL ASSEMBLY (for RHD) |
![]() |
Align the matchmarks and install the steering wheel to the steering column.
Install the nut.
Connect all the connectors to the spiral cable.
| 8. INSTALL STEERING PAD ASSEMBLY |
![]() |
Support the steering pad with one hand as shown in the illustration.
Connect the 2 airbag connectors.
Connect the horn connector.
Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.
Attach the 2 spring to steering pad.
| 9. INSPECT STEERING WHEEL CENTER POINT |
| 10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 11. INSPECT STEERING PAD ASSEMBLY |
Check for cuts, cracks or discoloration on the steering pad outer surface and in the grooved portion.
Check that the horn sounds.
| 12. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).