CAN COMMUNICATION SYSTEM > ABS and Traction Actuator (Skid Control ECU) Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| ABS and Traction Actuator (Skid Control ECU) Communication Stop Mode | Either condition is met:
|
|

| 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistance of the main wire and the branch wire.
| NEXT | |
| 2.CHECK FOR OPEN IN CAM BUS WIRE (ABS AND TRACTION ACTUATOR BRANCH WIRE) |
![]() |
Disconnect the A67 ABS and traction actuator (skid control ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A67-25 (CANH) - A67-14 (CANL) | Ignition switch off | 54 to 69 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (ABS AND TRACTION ACTUATOR - BATTERY AND BODY GROUND) |
Connect the cable to the negative (-) battery terminal.
![]() |
Disconnect the A67 ABS and traction actuator (skid control ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A67-13 (GND2) - Body ground | Always | Below 1 Ω |
| A67-1 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A67-34 (IG1) - Body ground | Ignition switch on (IG) | 11 to 14 V |
|
| ||||
| OK | ||
| ||