Home › BODY ELECTRICAL › DOOR LOCK › BACK DOOR LOCK

BACK DOOR LOCK > INSPECTION

for Preparation Click here



1. INSPECT BACK DOOR WITH MOTOR LOCK ASSEMBLY


    E123892E03
  1. Apply the battery voltage to the door lock motor and check the operation of the door lock motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 4 (ACT+)
    Battery negative (-) → 1 (ACT-)
    Lock
    Battery positive (+) → 1 (ACT-)
    Battery negative (-) → 4 (ACT+)
    Unlock

    1. If the result is not as specified, replace the door lock assembly.

  1. Measure the resistance of the door lock position switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    7 (S) - 8 (E)
    Lock
    10 kΩ or higher
    7 (S) - 8 (E)
    Unlock
    Below 1 Ω

    1. If the result is not as specified, replace the door lock assembly.