WIPER AND WASHER SYSTEM (w/ Rain Sensor) > Power Source Circuit |

| 1.INSPECT FUSE (WIP) |
Remove the WIP fuse from the instrument panel junction block.
Measure the resistance of the fuse.
|
| ||||
| OK | |
| 2.INSPECT IG1 RELAY |
![]() |
Remove the IG1 relay from the instrument panel junction block.
Measure the resistance of the relay.
| Tester Connection | Specified Condition |
| 3 - 5 | 10 kΩ or higher |
| Below 1 Ω (when battery voltage is applied to terminals 1 and 2) |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (RELAY - BATTERY AND BODY GROUND) |
![]() |
Disconnect the E66 relay connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Switch Condition | Specified Condition |
| E66-12 (IG) - Body ground | Ignition switch on (IG) | 10 to 14 V |
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| E66-26 (E) - Body ground | Below 1 Ω |
|
| ||||
| OK | ||
| ||