DTC B1207 Certification ECU Communication Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1207 | There is no communication from the certification ECU. |
|

| 1.CHECK FOR DTC |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Clear the DTC.
Check for DTC.
| Result | Proceed to |
| DTC is not output. | A |
| DTC is output. | B |
|
| ||||
| A | |
| 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistance of the main wire and the branch wire.
| NEXT | |
| 3.CHECK CAN BUS LINE FOR DISCONNECTION (CERTIFICATION ECU BRANCH WIRE) |
![]() |
Disconnect the E63 certification ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E63-27 (CANH) - E63-28 (CANL) | Ignition switch off | 54 to 69 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BATTERY AND BODY GROUND) |
Connect the cable to the negative (-) battery terminal.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E63-17 (E) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E63-1 (+B) - Body ground | Always | 11 to 14 V |
| E63-18 (IG) - Body ground | Ignition switch on (IG) | 11 to 14 V |
|
| ||||
| OK | ||
| ||