TRANSMISSION CONTROL CABLE > ADJUSTMENT |
| 1. ADJUST TRANSAXLE CONTROL CABLE ASSEMBLY |
![]() |
To release the lock (lock condition to lock release condition).
![]() |
Align the hole of the select outer lever with the hole in the transmission.
![]() |
Insert a bolt into the aligned holes to fix the select outer lever in place.
![]() |
Turn the shift lever in the reverse direction without pulling up the slider shaft.
![]() |
While holding the shift lever in the reverse direction, lock the cable length adjustment mechanism of the select cable.
![]() |
Remove the bolt to free the select outer lever.
![]() |
for new shift lever:
Remove the stopper pin and dispose of it.