Home › TRANSMISSION ยท E352F / E359F MANUAL TRANSAXLE › BACK-UP LIGHT SWITCH

BACK-UP LIGHT SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL BACK-UP LIGHT SWITCH ASSEMBLY
  1. Install the back-up light switch and gasket to the manual transaxle case.

    Torque:
    40 N*m{ 410 kgf*cm , 30 ft.*lbf }



    D026905E01
  1. Connect the back-up light switch connector.



2. INSTALL BATTERY CARRIER


A124829
  1. Install the battery carrier bracket with the nut and 2 bolts.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }



    A124828
  1. Install the battery bracket reinforcement with the 2 bolts.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }



    A124827
  1. Install the No. 1 battery carrier with the 4 bolts.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. Connect the 2 clamps of the engine wire.



3. INSTALL AIR CLEANER ASSEMBLY
  1. Connect the air cleaner case to the No. 1 air cleaner inlet.



    A112221
  1. Install the air cleaner case with the 3 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 ft.*lbf }

  1. Install the air cleaner filter element.



    A124825
  1. Connect the 2 clamps of the engine wire.

  1. Connect the mass air flow meter connector.



4. INSTALL PURGE VSV


A124790
  1. Install the purge VSV to the air cleaner hose.

  1. Connect the 2 purge line hoses to the purge VSV.

  1. Connect the wire harness clamp.

  1. Connect the purge VSV connector.



5. INSTALL BATTERY TRAY


6. INSTALL BATTERY
  1. Install the battery.

  1. Install the battery clamp and tighten the bolt and nut.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }