Home › TRANSMISSION ยท EB61 MANUAL TRANSAXLE › BACK-UP LIGHT SWITCH

BACK-UP LIGHT SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL BACK-UP LIGHT SWITCH ASSEMBLY


    C197734E01
  1. Using SST, install a new gasket and the back-up light switch to the transaxle case.

    SST
    09817-16011  

    Torque:
    40 N*m{ 410 kgf*cm , 30 ft.*lbf }

  1. Connect the back-up light switch connector.



2. INSTALL AIR CLEANER CASE


    A209057
  1. Install the air cleaner case with the 3 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Attach the wire harness clamp to the air cleaner case.



3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY


    A209052
  1. Insert the hinge part of the air cleaner cap and hose into the air cleaner case, and then fasten the 2 hook clamps.



    A211405E01
  1. Connect the No. 1 air cleaner hose to the throttle body and push apart the tabs of the No. 1 air cleaner hose clamp.

    HINT:
    The direction of the hose clamp is indicated in the illustration.

  1. Connect the No. 2 ventilation hose to the cylinder head cover.



    A209051
  1. Attach the clamp.

  1. Connect the mass air flow meter connector.



4. INSTALL NO. 2 CYLINDER HEAD COVER


    A209050
  1. Attach the 4 clips to install the cover.

    NOTICE:
    1. Be sure to attach the clips securely.
    2. Do not apply excessive force or do not hit the cover to attach the clips. This may cause the cover to break.