BACK-UP LIGHT SWITCH > INSTALLATION |
| 1. INSTALL BACK-UP LIGHT SWITCH ASSEMBLY |
![]() |
Using SST, install a new gasket and the back-up light switch to the transaxle case.
Connect the back-up light switch connector.
| 2. INSTALL AIR CLEANER CASE |
![]() |
Install the air cleaner case with the 3 bolts.
Attach the wire harness clamp to the air cleaner case.
| 3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Insert the hinge part of the air cleaner cap and hose into the air cleaner case, and then fasten the 2 hook clamps.
![]() |
Connect the No. 1 air cleaner hose to the throttle body and push apart the tabs of the No. 1 air cleaner hose clamp.
Connect the No. 2 ventilation hose to the cylinder head cover.
![]() |
Attach the clamp.
Connect the mass air flow meter connector.
| 4. INSTALL NO. 2 CYLINDER HEAD COVER |
![]() |
Attach the 4 clips to install the cover.