Home › TRANSMISSION ยท E352F / E359F MANUAL TRANSAXLE › BACK-UP LIGHT SWITCH

BACK-UP LIGHT SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE BATTERY
  1. Loosen the bolt and nut, and remove the battery clamp.

  1. Remove the battery.



3. REMOVE BATTERY TRAY


4. REMOVE PURGE VSV


A124790
  1. Disconnect the purge VSV connector.

  1. Disconnect the wire harness clamp.

  1. Disconnect the 2 purge line hoses from the purge VSV.

  1. Remove the purge VSV from the air cleaner hose.



5. REMOVE AIR CLEANER ASSEMBLY
  1. Disconnect the mass air flow meter connector.



    A124825
  1. Remove the 2 clamps of the engine wire.

  1. Remove the air cleaner filter element.



    A112221
  1. Remove the 4 bolts from the air cleaner case.

  1. Disconnect the air cleaner case from the No. 1 air cleaner inlet.



6. REMOVE BATTERY CARRIER


A124827
  1. Disconnect the 2 clamps of the engine wire.

  1. Remove the 4 bolts and No. 1 battery carrier.



    A124828
  1. Remove the 2 bolts and battery bracket reinforcement.



    A124829
  1. Remove the 2 bolts, nut and battery carrier bracket.



7. REMOVE BACK-UP LIGHT SWITCH ASSEMBLY


D026905E01
  1. Disconnect the back-up light switch connector.

  1. Remove the back up light switch and gasket from the manual transaxle case.