Home
›
ENGINE · 2AZ-FE
›
EMISSION CONTROL
›
AIR FUEL RATIO SENSOR
AIR FUEL RATIO SENSOR > INSPECTION
for Preparation
Click here
1. INSPECT AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
Measure the resistance of the sensor.
Standard resistance:
Tester Connection
Specified Condition
1 (HA1A) - 2 (+B)
1.8 to 3.4 Ω at 20°C (68°F)
1 (HA1A) - 4 (A1A-)
10 kΩ or higher
If the resistance is not as specified, replace the sensor.