Home › ENGINE · 3ZR-FAE › EMISSION CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > INSPECTION

for Preparation Click here



1. INSPECT HEATED OXYGEN SENSOR (for LHD)


    A210693E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    2 (HT1B) - 1 (+B)
    20°C (68°F)
    11 to 16 Ω
    2 (HT1B) - 3 (E2)
    Always
    10 kΩ or higher

    Text in Illustration 
    *1
    Component without harness connected
    (Heated Oxygen Sensor)
    If the result is not as specified, replace the sensor.



2. INSPECT HEATED OXYGEN SENSOR (for RHD)


    A210695E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (HT1B) - 2 (+B)
    20°C (68°F)
    11 to 16 Ω
    1 (HT1B) - 4 (E2)
    Always
    10 kΩ or higher

    Text in Illustration 
    *1
    Component without harness connected
    (Heated Oxygen Sensor)
    If the result is not as specified, replace the sensor.