Home › BRAKE › PARKING BRAKE › PARKING BRAKE LEVER

PARKING BRAKE LEVER > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK PARKING BRAKE SWITCH ASSEMBLY
  1. Remove the rear console box (Click here).

    HINT:
    Refer to the procedures from the removal of the No. 1 console upper panel garnish up until the removal of the rear console box sub-assembly.

  1. Disconnect the parking brake switch connector.



    C118703E02
  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - Body ground
    Parking brake switch ON (Switch pin released)
    Below 1 Ω
    1 - Body ground
    Parking brake switch OFF (Switch pin pushed in)
    10 kΩ or higher

    If the result is not as specified, replace the switch assembly.