Home › ENGINE ยท 2AZ-FE › COOLING › COOLING FAN MOTOR

COOLING FAN MOTOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT NO. 1 COOLING FAN MOTOR


    A127844E01
  1. Disconnect the No. 1 fan connector.

  1. Connect the battery and ammeter to the No. 1 fan motor connector.

  1. Check that the No. 1 fan rotates smoothly, and then check the reading on the ammeter.

    Standard amperage:
    Indication Mark
    Motor Type
    Condition
    Specified Condition
    A
    80 W
    At 20°C (68°F)
    5.8 to 7.8 A
    B, C
    160 W
    At 20°C (68°F)
    11.7 to 14.7 A

    HINT:
    Refer to the illustration for the indication mark location.

    If the result is not as specified, replace the No. 1 cooling fan motor.

  1. Reconnect the No. 1 fan motor connector.



2. INSPECT NO. 2 COOLING FAN MOTOR


    A127845E01
  1. Disconnect the No. 2 fan connector.

  1. Connect the battery and ammeter to the No. 2 fan motor connector.

  1. Check that the No. 2 fan rotates smoothly, and then check the reading on the ammeter.

    Standard amperage:
    Indication Mark
    Motor Type
    Condition
    Specified Condition
    A
    80 W
    At 20°C (68°F)
    5.8 to 7.8 A
    B
    120 W
    At 20°C (68°F)
    8.4 to 10.4 A
    C
    160 W
    At 20°C (68°F)
    11.7 to 14.7 A

    HINT:
    Refer to the illustration for the indication mark location.

    If the result is not as specified, replace the No. 2 cooling fan motor.

  1. Reconnect the No. 2 fan motor connector.