Home › DRIVE LINE › DIFFERENTIAL › ACTIVE TORQUE CONTROL 4WD SYSTEM

ACTIVE TORQUE CONTROL 4WD SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK 4WD CONTROL ECU

G032017E03

  1. Measure the voltage and resistance of the connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    CANH (E67-14) - CANL (E67-16)
    P - W
    CAN communication
    Ignition switch off
    54 to 69 Ω
    GND (E67-23) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    4WDL (E67-7) - Body ground
    R - Body ground
    Ground
    Press continuously 4WD lock mode switch
    Below 1 Ω
    IG1 (E67-11) - GND (E67-23)
    L - W-B
    Power source voltage
    Ignition switch on (IG)
    10 to 14 V
    SLC+ (E67-13) - SLC- (E67-32)
    W - B
    4WD linear solenoid signal
    Ignition switch on (IG)
    Pulse generation (See waveform 1)
    BSLC (E67-9) - GND (E67-23)
    R - W-B
    Power source voltage
    Ignition switch on (IG)
    10 to 14 V
    If the result is not as specified, the 4WD control ECU may have a malfunction.



  2. C065158E02
  3. Using an oscilloscope, check the waveform 1.

Waveform 1 (Reference)  
Symbols (Terminal No.)
Content
Tool setting
5 V/DIV., 2 msec. / DIV.
Vehicle condition
Engine stop, ignition switch on (IG)