DTC C1297/97 Steering Angle Sensor |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1297/97 | When voltage of 4WD control ECU IG1 terminal is 9.5 V or more, and steering angle sensor malfunction signal is received. |
|

| 1.CHECK FOR DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Turn the ignition switch on (IG) again and check that no CAN communication system DTC(s) is output.
Start the engine.
Drive the vehicle and turn the steering wheel to the right and left at a speed of 35 km/h (22 mph) and check that no brake control system (steering angle sensor) DTC (C1432,C1433 or C1434) is output (Click here).
| Result | Proceed to | ||
| Neither CAN communication system DTC nor brake control system DTC is output | A | ||
| CAN communication system DTC is output | B | ||
| Brake control system (steering angle sensor) DTC (C1432,C1433 or C1434) is output | C |
|
| ||||
|
| ||||
| A | |
| 2.CHECK WIRE HARNESS (STEERING ANGLE SENSOR - BATTERY) |
![]() |
Disconnect the E95 sensor connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Condition | Specified Condition | |||
| E95-4 (IG) - Body ground | Ignition switch on (IG) | 10 to 14 V | |||
| E95-5 (BAT) - Body ground | Always | 10 to 14 V | |||
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (STEERING ANGLE SENSOR - BODY GROUND) |
![]() |
Disconnect the E95 sensor connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| E95-1 (ESS) - Body ground | Always | Below 1 Ω |
| Result | Proceed to |
| OK (When troubleshooting according to DTC chart) | A |
| OK (When troubleshooting according to PROBLEM SYMPTOMS TABLE) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||