Home › DRIVE LINE › DIFFERENTIAL › ACTIVE TORQUE CONTROL 4WD SYSTEM

DTC    C1298/98    Linear Solenoid Circuit

for Preparation Click here


DESCRIPTION

The 4WD control ECU receives signals from each sensor to control clutch fluid pressure for limiting the center differential operation, which distributes torque according to the driving conditions.

DTC No.
DTC Detection Condition
Trouble Area
C1298/98
  1. When all of the following continue for 1 second or more:
    - IG1 voltage is 9.5 V or more.
    - Current is either 0 A or greater than 0.8 A .
    - Open or short occurs in the linear solenoid circuit.
  1. 4WD fuse
  2. Wire harness
  1. Electromagnetic coupling
  1. 4WD control ECU

WIRING DIAGRAM


C212561E03


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT:
Check the condition of each related circuit connector before troubleshooting (Click here).

1.CHECK WIRE HARNESS (4WD CONTROL ECU BSLC TERMINAL)
  1. Disconnect the E67 ECU connector.



    C107387E25
  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E67-9 (BSLC) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2.INSPECT ELECTROMAGNETIC COUPLING (4WD LINEAR SOLENOID)
C131916E01
  1. Remove the coupling connector.

  1. Measure the resistance of the solenoid.

    Standard resistance:
    Tester Connection
    Specified Condition
    1 (BSF) - 2 (SLC)
    2.2 to 2.6 Ω
    1 (BSF) - Body ground
    10 kΩ or higher
    2 (SLC) - Body ground
    10 kΩ or higher



NG
REPLACE ELECTROMAGNETIC COUPLING
OK


3.CHECK WIRE HARNESS (COUPLING - 4WD CONTROL ECU)
C130947E01
  1. Disconnect the E67 ECU connector.

  1. Measure the resistance of the wire harness side connectors

    Standard resistance:
    Tester Connection
    Specified Condition
    E67-13 (SLC+) - Q1-1 (BSF)
    Below 1 Ω
    E67-32 (SLC-) - Q1-2 (SLC)
    Below 1 Ω
    E67-13 (SLC+) - Body ground
    10 kΩ or higher
    E67-32 (SLC-) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE 4WD CONTROL ECU