DTC C1241/94 Low Power Supply Voltage |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1241/94 | When one of following conditions is met:
|
|

| 1.CHECK FOR DTC |
Clear the DTC (Click here).
Turn the ignition switch on (IG) and check that no CAN communication system DTC is output.
Start the engine.
Drive the vehicle, accelerate to a speed of 3 km/h (2 mph) or more, and check that no speed sensor DTC (brake control system DTC) is output (Click here and Click here).
| Result | Proceed to | ||
| Neither CAN communication system DTC nor speed sensor DTC (Brake control system DTC) is output | A | ||
| CAN communication system DTC is output | B | ||
| Speed sensor DTC (Brake control system DTC) is output | C |
|
| ||||
|
| ||||
| A | |
| 2.INSPECT FUSE (ECU-IG1) |
Remove the ECU-IG1 fuse from the instrument junction block.
Measure the resistance of the fuse.
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (4WD CONTROL ECU - BATTERY) |
![]() |
Disconnect the E67 ECU connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| E67-11 (IG1) - Body ground | Ignition switch on (IG) | 10 to 14 V |
|
| ||||
| OK | |
| 4.CHECK WIRE HARNESS (4WD CONTROL ECU - BODY GROUND) |
![]() |
Disconnect the E67 ECU connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| E67-23 (GND) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 5.RECONFIRM DTC |
Clear the DTC (Click here).
Start the engine.
Drive the vehicle, accelerate to a speed of 3 km/h (2 mph) or more, and check if the same DTC is output.
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||