Home › DRIVE LINE › DIFFERENTIAL › ACTIVE TORQUE CONTROL 4WD SYSTEM

ACTIVE TORQUE CONTROL 4WD SYSTEM > 4WD Indicator Light Remains ON

for Preparation Click here


DESCRIPTION

The 4WD control ECU is connected to the combination meter via the CAN communication system.
  1. w/ Multi-information display:
    If the 4WD control ECU stores any DTCs which are related to the active torque control system, the meter caution indicator light comes on and the warning message is displayed on the multi-information display in the combination meter.
  1. w/o Multi-information display:
    If the 4WD control ECU stores any DTCs which are related to the active torque control system, the 4WD indicator light comes on in the combination meter.

WIRING DIAGRAM


C204189E02


INSPECTION PROCEDURE

HINT:
Check the condition of each related circuit connector before troubleshooting (Click here).

1.CHECK FOR DTC
  1. Check the output DTC (Click here).


Result:

Result
Proceed to
Neither CAN communication system DTC nor 4WD control system DTC is output
A
CAN communication DTC is output
B
4WD control system DTC is output
C

HINT:
When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.



B
REPAIR CIRCUIT INDICATOR BY OUTPUT CODE (CAN COMMUNICATION SYSTEM)

C
REPAIR CIRCUIT INDICATOR BY OUTPUT CODE (4WD CONTROL SYSTEM)
A


2.CHECK WIRE HARNESS (4WD CONTROL ECU - BATTERY)
C107387E07
  1. Disconnect the E67 ECU connector.

  1. Measure the voltage of the wire harness side connector.

Voltage:
Tester Connection
Condition
Specified Condition
E67-11 (IG1) - Body ground
Ignition switch on (IG)
10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK COMBINATION METER
  1. Check the combination meter (Click here).

    OK:
    The combination meter is normal.



NG
REPLACE COMBINATION METER
OK

REPLACE 4WD CONTROL ECU