ENGINE SWITCH (w/ Entry and Start System) > INSTALLATION |
| 1. INSTALL ENGINE SWITCH |
![]() |
Attach the 2 claws and install the switch.
Connect the switch connector.
| 2. INSTALL HEATER CONTROL ASSEMBLY |
![]() |
Connect the connectors.
Attach the 3 clips to install the heater control assembly.
Install the 2 screws.
| 3. INSTALL RADIO RECEIVER (w/ Radio Receiver) |
for 3ZR-FAE
Install the radio receiver assembly with bracket .
for 3ZR-FAE
Install the radio receiver assembly with bracket .
| 4. INSTALL STEREO OPENING COVER (w/o Radio Receiver) |
![]() |
Attach the 4 clips to install the stereo opening cover.
Install the 4 bolts.
| 5. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL CENTER |
![]() |
Connect the connector.
Attach the 3 clips and 2 claws to install the cluster finish panel.
| 6. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL CENTER |
![]() |
Connect the connector.
Attach the 3 clips and 2 claws to install the cluster finish panel.
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |