Home › ENGINE ยท 1AZ-FE › STARTING › ENGINE SWITCH (w/ Entry and Start System)

ENGINE SWITCH (w/ Entry and Start System) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL CENTER


    B208365
  1. Using a moulding remover, detach the 3 clips and 2 claws, and then remove the cluster finish panel.

  1. Disconnect the connector.



3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL CENTER


    B208366
  1. Using a moulding remover, detach the 3 clips and 2 claws, and then remove the cluster finish panel.

  1. Disconnect the connector.



4. REMOVE RADIO RECEIVER (w/ Radio Receiver)
  1. for 3ZR-FAE:
    Remove the radio receiver assembly with bracket .

  1. except 3ZR-FAE
    Remove the radio receiver assembly with bracket .



5. REMOVE STEREO OPENING COVER (w/o Radio Receiver)


B133002
  1. Remove the 4 bolts.

  1. Detach the 4 clips and remove the stereo opening cover.



6. REMOVE HEATER CONTROL ASSEMBLY


    A133122
  1. Remove the 2 screws.

  1. Using a screwdriver detach the 3 clips.

    HINT:
    Tape the screwdriver tip before use.

  1. Connect the connectors and remove the heater control assembly.



7. REMOVE ENGINE SWITCH


    A133129E01
  1. Disconnect the switch connector.

  1. Detach the 2 claws and remove the switch.