ENGINE SWITCH (w/ Entry and Start System) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL CENTER |
![]() |
Using a moulding remover, detach the 3 clips and 2 claws, and then remove the cluster finish panel.
Disconnect the connector.
| 3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL CENTER |
![]() |
Using a moulding remover, detach the 3 clips and 2 claws, and then remove the cluster finish panel.
Disconnect the connector.
| 4. REMOVE RADIO RECEIVER (w/ Radio Receiver) |
for 3ZR-FAE:
Remove the radio receiver assembly with bracket .
except 3ZR-FAE
Remove the radio receiver assembly with bracket .
| 5. REMOVE STEREO OPENING COVER (w/o Radio Receiver) |
![]() |
Remove the 4 bolts.
Detach the 4 clips and remove the stereo opening cover.
| 6. REMOVE HEATER CONTROL ASSEMBLY |
![]() |
Remove the 2 screws.
Using a screwdriver, detach the 3 clips.
Connect the connectors and remove the heater control assembly.
| 7. REMOVE ENGINE SWITCH |
![]() |
Disconnect the switch connector.
Detach the 2 claws and remove the switch.