NAVIGATION SYSTEM (for HDD) > Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (STEREO JACK ADAPTER - NAVIGATION RECEIVER) |
![]() |
Disconnect the E100 stereo jack adapter connector.
![]() |
Disconnect the E106 navigation receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E100-1 (ALO) - E106-17 (ALI) | Always | Below 1 Ω |
| E100-2 (ARO) - E106-15 (ARI) | Always | Below 1 Ω |
| E100-3 (ASGN) - E106-16 (ASGN) | Always | Below 1 Ω |
| E100-4 (AUXO) - E106-19 (AUXI) | Always | Below 1 Ω |
| E100-5 (AGND) - E106-18 (AGND) | Always | Below 1 Ω |
| E100-1 (ALO) - Body ground | Always | 10 kΩ or higher |
| E100-2 (ARO) - Body ground | Always | 10 kΩ or higher |
| E100-3 (ASGN) - Body ground | Always | 10 kΩ or higher |
| E100-4 (AUXO) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||