OUTPUT SHAFT > DISASSEMBLY |
| 1. INSPECT 1ST GEAR THRUST CLEARANCE |
![]() |
Using a feeler gauge, measure the thrust clearance.
| 2. INSPECT 2ND GEAR THRUST CLEARANCE |
![]() |
Using a dial indicator, measure the thrust clearance.
| 3. INSPECT 1ST GEAR RADIAL CLEARANCE |
![]() |
Using a dial indicator, measure the radial clearance.
| Bearing | Specified Condition |
| KOYO made | 0.009 to 0.053 mm (0.0004 to 0.0021 in.) |
| NSK made | 0.009 to 0.051 mm (0.0004 to 0.0020 in.) |
| 4. INSPECT 2ND GEAR RADIAL CLEARANCE |
![]() |
Using a dial indicator, measure the radial clearance.
| Bearing | Specified Condition |
| KOYO made | 0.009 to 0.053 mm (0.0004 to 0.0021 in.) |
| NSK made | 0.009 to 0.051 mm (0.0004 to 0.0020 in.) |
| 5. REMOVE 4TH DRIVEN GEAR |
![]() |
Using SST and a press, press out the output shaft rear bearing (inner race) and 4th driven gear.
| 6. REMOVE OUTPUT GEAR SPACER |
![]() |
Remove the output gear spacer from the output shaft.
| 7. REMOVE 2ND GEAR |
![]() |
Using SST and a press, press out the 3rd driven gear and 2nd gear from the output shaft.
| 8. REMOVE NO. 2 SYNCHRONIZER RING SET |
![]() |
Remove the No. 2 synchronizer ring set from the No. 1 transaxle clutch hub.
| 9. REMOVE 2ND GEAR NEEDLE ROLLER BEARING |
![]() |
Remove the needle roller bearing from the output shaft.
| 10. REMOVE 2ND GEAR BEARING SPACER |
![]() |
Remove the bearing spacer from the output shaft.
| 11. REMOVE 2ND GEAR BUSH |
![]() |
Remove the bush from the output shaft.
| 12. REMOVE 2ND GEAR BUSH BALL |
![]() |
Using a magnetic finger, remove the bush ball from the output shaft.
| 13. REMOVE 1ST GEAR |
![]() |
Using SST and a press, remove the No. 1 transaxle clutch hub and 1st gear from the output shaft.
| 14. REMOVE NO. 1 SYNCHRONIZER RING SET |
![]() |
Remove the No. 1 synchronizer ring set from the 1st gear.
| 15. REMOVE 1ST GEAR NEEDLE ROLLER BEARING |
![]() |
Remove the needle roller bearing from the output shaft.
| 16. REMOVE FRONT OUTPUT SHAFT BEARING |
![]() |
Using SST and a press, press out the front bearing (inner race) from the output shaft.
| 17. REMOVE REVERSE GEAR |
![]() |
Remove the No. 1 transaxle clutch hub, 3 No. 1 synchromesh shifting keys and 3 No. 1 synchromesh shifting key springs from the reverse gear.