SHIFT AND SELECT LEVER SHAFT > DISASSEMBLY |
| 1. REMOVE SHIFT AND SELECT LEVER BUSH |
![]() |
Remove the bush from the No. 2 selecting bellcrank.
| 2. REMOVE NO. 1 SELECTING BELLCRANK DUST COVER |
![]() |
Remove the dust cover from the No. 2 selecting bellcrank.
| 3. REMOVE SELECTING BELLCRANK SUPPORT SUB-ASSEMBLY |
![]() |
Remove the nut, wave washer and No. 2 selecting bellcrank plate washer from the No. 2 selecting bellcrank.
![]() |
Remove the selecting bellcrank support from the No. 2 selecting bellcrank.
| 4. REMOVE NO. 2 SELECTING BELLCRANK DUST COVER |
![]() |
Remove the dust cover from the No. 2 selecting bellcrank.
| 5. REMOVE NO. 2 SELECTING BELLCRANK BUSH |
![]() |
Remove the bushes from the No. 2 selecting bellcrank.
| 6. REMOVE NO. 2 SHIFT LEVER INNER |
![]() |
Hold the shift and select lever shaft in a vise with soft jaws.
Using a 5 mm pin punch and hammer, tap out the slotted pin and remove the transaxle oil baffle.
![]() |
Apply force to the No. 2 select return compression spring, then using 2 screwdrivers and a hammer, tap out the No. 2 select spring seat shaft snap ring from the shift and select lever shaft.
Remove the No. 2 select spring seat, No. 2 select return compression spring and No. 2 shift lever inner.
![]() |
Remove the No. 2 select spring seat, No. 2 select return compression spring and No. 2 shift lever inner from the shift and select lever shaft.
| 7. REMOVE NO. 1 SELECT SPRING SEAT |
![]() |
Using a 5 mm pin punch and hammer, tap out the slotted pin from the shift and select lever shaft.
![]() |
Remove the shift inter lock plate assembly, shift lever assembly, No. 1 select return compression spring and No. 1 select spring seat from the shift and select lever shaft.
| 8. REMOVE SHIFT INTER LOCK PLATE COVER |
![]() |
Remove the shift inter lock plate cover from the shift inter lock plate.
| 9. REMOVE NO. 1 SHIFT LEVER INNER |
![]() |
Remove the No. 1 shift lever inner from the shift inter lock plate.
| 10. REMOVE NO. 1 SELECT SPRING SEAT SHAFT SNAP RING |
![]() |
Using 2 screwdrivers and a hammer, tap out the snap ring.
| 11. REMOVE SHIFT AND SELECT LEVER SHAFT DUST BOOT |
Remove the dust boot from the control shaft cover.
| 12. REMOVE CONTROL SHAFT COVER OIL SEAL |
![]() |
Using a screwdriver, pry out the oil seal from the control shaft cover.