DIFFERENTIAL CASE > REASSEMBLY |
| 1. INSTALL FRONT DIFFERENTIAL SIDE GEAR |
![]() |
Coat the rotating surfaces of the differential side gears with gear oil.
Install the 2 differential side gear thrust washers to the 2 differential side gears.
Install the 2 differential side gears, 2 differential pinions and 2 differential side gear thrust washers to the differential case.
| 2. INSTALL FRONT NO. 1 DIFFERENTIAL PINION SHAFT |
![]() |
Coat the rotating surface of the No. 1 differential pinion shaft with gear oil.
Install the No. 1 differential pinion shaft to the differential case so that the hole for the differential pinion shaft straight pin is aligned with the hole in the differential case.
| 3. INSTALL FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN |
![]() |
Using a pin punch and hammer, tap in the differential pinion shaft straight pin to the differential case.
![]() |
Using a chisel and hammer, stake the differential case hole.
| 4. ADJUST FRONT DIFFERENTIAL SIDE GEAR BACKLASH |
![]() |
Hold the differential pinion to the differential case side. Using a dial indicator, measure the differential side gear backlash.
| Part No. | Mark | Thickness |
| 41361-28230 | 1 | 1.00 mm (0.394 in.) |
| 41361-28240 | 2 | 1.10 mm (0.0433 in.) |
| 41361-28250 | 3 | 1.20 mm (0.0472 in.) |
| 41361-28260 | 4 | 1.30 mm (0.512 in.) |
| 5. INSTALL FRONT DIFFERENTIAL RING GEAR |
![]() |
Clean the contact surface of the differential case and differential ring gear.
Using a heater, heat the differential ring gear to 90 to 110°C (194 to 230°F).
After the moisture on the ring gear has completely evaporated, quickly install the differential ring gear to the differential case.
![]() |
Aligning the matchmarks, quickly install the front differential ring gear to the differential case with the 16 bolts.
| 6. INSTALL SPEEDOMETER DRIVE GEAR |
![]() |
Install the drive gear to the differential case.