Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Tachometer Malfunction

for Preparation Click here


DESCRIPTION

The combination meter assembly controls the tachometer in accordance with engine speed signals from the ECM through the CAN communication system.

WIRING DIAGRAM


E124226E01


INSPECTION PROCEDURE

HINT:
If DTC U0100 has been stored, troubleshoot the CAN communication system first.

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (TachoMeter Operation)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Perform the Active Test according to the prompts displayed on the tester.

    Combination meter 
    Tester Display
    Test Part
    Control Range
    TachoMeter Operation
    0 / 1,000 / 2,000 / 3,000 / 4,000 / 5,000 / 6,000 / 7,000 rpm
    Value selected during Active Test is displayed

    OK:
    Engine speed displayed on the tester is almost the same as that of the tachometer reading.



NG
REPLACE COMBINATION METER ASSEMBLY
OK


2.READ VALUE USING DATA LIST (Engine Rpm)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Read the Data List according to the prompts displayed on the tester.

    Combination meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Engine Rpm
    Engine speed / Min.: 0 rpm, Max.: 12,750 rpm
    Almost same as actual engine speed
    (When engine is running)
    -

    OK:
    Engine speed displayed on the tester is almost the same as the actual engine speed.



NG
REPLACE COMBINATION METER ASSEMBLY
OK

GO TO SFI SYSTEM