Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Engine Coolant Temperature Receiver Gauge Malfunction

for Preparation Click here


DESCRIPTION

The combination meter assembly receives the engine coolant temperature sensor signal from the ECM and displays it using CAN communication.

WIRING DIAGRAM


E124226E01


INSPECTION PROCEDURE

HINT:
  1. If DTC U0100 has been stored, troubleshoot the CAN communication system first.
  2. If there is an open or short in the engine coolant temperature sensor circuit, an SFI system DTC is output. If output, perform troubleshooting on the SFI system.

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (Water Temperature Meter Operation)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Perform the ACTIVE TEST according to the prompts displayed on the tester.

    Combination meter 
    Tester Display
    Test Part
    Control Range
    Water Temperature Meter Operation
    LOW / NORMAL / HIGH
    Value selected during Active Test is displayed

    OK:
    Value selected during Active Test is displayed.



NG
REPLACE COMBINATION METER ASSEMBLY
OK


2.READ VALUE USING DATA LIST (Coolant Temperature)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and the tester ON.

  1. Read the Data List according to the prompts displayed on the tester.

    Combination meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Coolant Temperature
    Coolant temperature / Min.: 0°C (32°F), Max.: 127.5°C (261.5°F)
    After warming up: 80 to 95°C (176 to 203°F)
    If the value is "0°C (32°F)" or "127.5°C (261.5°F)", sensor circuits are open or shorted.

    OK:
    Vehicle's coolant temperature and tester value are the same.



NG
REPLACE COMBINATION METER ASSEMBLY
OK

GO TO SFI or ECD SYSTEM