Home › TRANSMISSION ยท K111F CVT › TRANSAXLE OIL PAN

TRANSAXLE OIL PAN > REMOVAL



1. REMOVE NO. 1 ENGINE UNDER COVER


    A206200
  1. Remove the 6 screws, 10 clips and under cover.



2. REMOVE REAR ENGINE UNDER COVER LH


    A196893
  1. Remove the 2 clips and under cover.



3. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT LH


    A206203
  1. Remove the 4 bolts and reinforcement.



4. REMOVE NO. 1 TRANSMISSION OIL FILLER TUBE


    C242832
  1. Using a 6 mm socket hexagon wrench, remove the overflow plug and gasket from the continuously variable transaxle assembly.



    C242875E01
  1. Using a 6 mm socket hexagon wrench, remove the No. 1 transmission oil filler tube from the oil pan and drain the continuously variable transaxle fluid.
    Text in Illustration 
    *1
    No. 1 Transmission Oil Filler Tube



5. REMOVE TRANSAXLE OIL PAN SUB-ASSEMBLY


    C200350
  1. Remove the 19 bolts and oil pan from the transaxle.

    NOTICE:
    Some fluid will remain in the oil pan. To prevent the fluid from spilling, place a container under the oil pan, and then carefully remove all the pan bolts and oil pan assembly.

  1. Remove the gasket from the oil pan.



    C103347E02
  1. Remove the 3 magnets from the oil pan.
    Text in Illustration 
    *1
    Magnet

    NOTICE:
    1. Clean the oil pan and remove any metal particles, sludge, etc.
    2. Clean off any metal particles that adhere to the magnets.