Home › TRANSMISSION ยท K111F CVT › OIL PRESSURE SENSOR

OIL PRESSURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL OIL PRESSURE SENSOR
  1. Coat the O-ring of the pressure sensor with Toyota Genuine CVT fluid TC.



    C203368E01
  1. Using SST, install the oil pressure sensor.

    SST
    09326-22011  

    Torque:
    without SST:
    21 N*m{ 210 kgf*cm , 15 ft.*lbf }
    with SST:
    16 N*m{ 159 kgf*cm , 12 ft.*lbf }

    NOTICE:
    1. The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 155 mm (6.10 in.).
    2. The "with SST" torque value is effective when SST is parallel to the torque wrench.



    C203367
  1. Connect the oil pressure sensor connector.



2. INSTALL REAR ENGINE UNDER COVER LH


    A196893
  1. Install the under cover with the 2 clips.



3. INSTALL FRONT WHEEL LH

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }



4. RESET MEMORY
  1. Perform Reset Memory (CVT initialization) when replacing the oil pressure sensor (Click here).