SHIFT LEVER > INSTALLATION |
| 1. INSTALL FLOOR SHIFT ASSEMBLY |

Install the floor shift with the 4 bolts. Tighten the bolts in the order shown in the illustration.
Connect the 2 connectors and attach the 2 harness clamps to the floor shift.
| 2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY |
Turn the nut of the transmission control cable 180° counterclockwise. While holding the nut in place, push in the stopper to lock the nut.

| *1 | Stopper | *2 | Nut |
Install the outer part of the transmission control cable to the shift lever retainer. Check that the stopper returns to the pulled out position.

| *1 | Stopper | *2 | Nut |
| *3 | Shift Lever Retainer | - | - |
![]() |
Slide the slider in the direction shown in the illustration and pull out the lock piece.
| *1 | Slider |
| *2 | Lock Piece |
![]() |
Connect the end of the cable to the shift lever.
![]() |
Gently pull the cable rod toward the rear of the vehicle by hand to pull the cable taut.
Push the lock piece into the adjuster case and lock it.
| *1 | Cable Rod |
| 3. INSPECT SHIFT LEVER POSITION |
When moving the shift lever from P to R with the ignition switch ON and the brake pedal depressed, make sure that the shift lever moves smoothly and correctly into position.
Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D and moves in reverse after moving the shift lever to R.
If the operation cannot be performed as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.
| 4. ADJUST SHIFT LEVER POSITION |
Remove the rear console box sub-assembly (Click here).
Apply the parking brake and move the shift lever to N.
![]() |
Slide the slider in the direction shown in the illustration and pull out the lock piece.
| *1 | Slider |
| *2 | Lock Piece |
![]() |
Gently pull the cable rod toward the rear of the vehicle by hand to pull the cable taut.
| *1 | Cable Rod |
Press the lock piece into the adjuster case and lock it.
Inspect the operation of the shift lever (Click here).
Install the rear console box sub-assembly (Click here).
| 5. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY |
Install the rear console box (Click here).